Method of Fault Inspection of Thin Oil Lubrication Pump

Ways to troubleshoot

First press the RST button to reset and observe if the gauge is under pressure

If no pressure is displayed, check again if the motor is working

Please note that please turn off the power and wait for 10-15 minutes, and then start the oil pump after the motor temperature cools down

The intermittent oil pump is equipped with overheating protection to prevent overload due to excessive temperature, and remember not to run the machine continuously. If you want to use the oil pump frequently, set it to 15-20 minutes.

Check that the tubing is not oiling

The outlet pipe can be folded in half

Or plug the oil outlet

Being able to pressurize is a problem with the pipeline

Note that the air in the pipe must be discharged before use, as poor operation will cause the oil pipe to rupture and leak, and the pressure will not be lost.

In case of pressure, the regulator can be adjusted

Tighten and pressurize, loosen and decompress

The most important thing is the oil

Lubricating oil with too low viscosity can lead to insufficient pump pressure.....